Removing and Replacing an I/O Module

Caution: Use ESD precautions when performing these procedures.
Précaution: Utilisez les précautions ESD lors de l'exécution de ces procédures.
Notice: Be sure to read Replacing System Components before you remove any system components.

To remove an I/O module

  1. Disconnect all cables from the I/O module.

  2. Use your index finger to unlatch the release lever on the I/O module.

  3. Grasp the release lever and pull it down until it is fully extended and the I/O module extends an inch or two from the system chassis. See Figure 40.

    Figure 40: Removing I/O Module

    Caution: The release lever must be fully extended as shown in the figure before you perform step 4.
    Précaution: Le levier de déverrouillage doit être complètement étendu comme indiqué sur la figure avant d'effectuer l'étape 4.

  4. Holding the I/O module on each side, pull it straight out of the system chassis and place it on a flat, stable surface.

To replace an I/O module

  1. Extend the release lever on the I/O module until it is fully open.

  2. Slide the I/O module into the system chassis until it stops. Ensure that the module is fully seated and aligns with the system chassis.

  3. Push on the center of the I/O module with one hand while simultaneously using your other hand to push up the release lever until it clicks. See Figure 41.

    Figure 41: Replacing I/O Module

  4. Push on the center of the I/O module once more to make sure it is fully seated in the system chassis.

  5. Connect all of the cables.

Related Topics