Replacing and Adding RDIMMs

You install RDIMMs when upgrading system memory or replacing a faulty RDIMM. Before you install RDIMMs, read Memory in ztC Endurance Systems.

Caution: Use ESD precautions when performing these procedures.
Précaution: Utilisez les précautions ESD lors de l'exécution de ces procédures.
Note: When you install RDIMMs, you do not need to schedule any downtime because you remove only one compute module at a time.
Notice: If you require assistance while adding RDIMMs, your authorized Stratus service representative can provide onsite installation services for a fee.

To remove RDIMMs

  1. Remove the compute module whose RDIMMs you are upgrading.

  2. Push down on the ejector levers at each end of the RDIMM to be removed. See Figure 32.

    Figure 32: Removing RDIMM

    1

    Ejector levers

  3. Pull the RDIMM straight up to remove it from the connector.

To install RDIMMs

  1. Make sure you are installing the RDIMM in the correct slot. See Figure 4.

  2. With the RDIMM connector ejector levers in the open position (down), align the small slots on the base of the RDIMM with the notches at the base of the connector. Push the RDIMM down firmly into place. Make sure it is fully seated.

  3. Ensure that the connector's ejector levers are raised and fully locked into place. If they are not, eject and reseat the RDIMM.

  4. Repeat Steps 1 and 2 for any additional RDIMMs.

  5. After installing the RDIMMs, replace the compute module.